Lancia Lybra Owner's Handbook Manual - page 98
97
Resetting for use
The sound system will be electroni-
cally protected if the code is on and
the electrical power is disconnected
(e.g. if the battery is disconnected for
servicing).
Reconnect the electrical power and
proceed as follows:
1) Switch the sound system on. The
message “SAFE” will appear on the
display. After approximately three
seconds the message “1 - - - - “ will
appear. “1” identifies the number of
attempts to enter the code.
2) Enter the code (see “Safety
code”) as described in “Activating the
code” by pressing the buttons num-
bered from 2 to 5.
3) To confirm the code: press the
EXP 14 button briefly. The message
“SAFE” will appear temporarily on
the display. The sound system will
start working after approximately
three seconds.
IMPORTANT If an incorrect code is
entered, the message “SAFE” will re-
main on the display and the sound
system will not work. Repeat the en-
tire procedure.
Respect stand-by times between at-
tempts (see “Stand-by times”).
Stand-by times
Specific stand-by times (between at-
tempts) are featured to avoid entering
and deactivating the code by at-
tempts. During the stand-by time, the
sound system can be switched on and
off but it will not work.
Do not switch the sound system on
during the stand-by times. The sound
system, however, should be connected
to the electrical power.
The message “SAFE” will appear on
the display to indicate the stand-by
time is not over.
The digit indicating the following at-
tempt (e.g. “2 - - - -”) will appear on
the display when the stand-by time is
over.
The following table shows the stand-
by times between attempts.
After the sixth attempt, we recom-
mend you contact a Lancia Dealer-
ship either to have the secret code en-
tered or deactivated.