Lantronix EPS2-100 Installation Manual - 4.1 Setting The Ip Address

TCP/IP Configuration

4 - 2

4.1 Setting the IP Address

The EPS IP address must be configured before any TCP/IP functionality is available.

To set the IP address, use one of the following methods: EZWebCon; a directed Ping packet; a 

DHCP, BOOTP, or RARP reply; or commands entered at the command line (Local>) interface. 

4.1.1 Using EZWebCon

The EPS must have an IP address before you can log into it using EZWebCon. To assign the IP 

address from EZWebCon:

1.

Start EZWebCon. Instructions for installing, running, and using EZWebCon can be found 

on the distribution CD-ROM.

2.

Click on the Lantronix logo menu in the bottom left corner of the EZWebCon window, 

then select Assign IP Address to Server.

3.

Fill in the following information:

A. The last three bytes of the EPS’s hardware address. The hardware address is printed 

on the bottom of the Server.

B. The desired IP address.

C. The subnet, if you wish to use a subnet other than the default.