Lantronix EPS2-100 Installation Manual - I - Troubleshooting
of
114
Troubleshooting
I - 1
I - Troubleshooting
I.1 Power-Up Troubleshooting
There are several possible error situations if the LEDs do not flash.
Table I-1: Error Messages
Message
Diagnosis/Remedy
Power-up diagnostic failure (hardware fail-
ure)
Note which LED is blinking and its color, then contact your
dealer or Lantronix Technical Support.
The Server boots but does not try to load the
Flash ROM code
Press the Test button. A brief description of the problem will
be queued to the parallel port and printed.
Network Error: The ACT LED will blink
yellow 2-3 times per second
A. Make sure the Ethernet network cable is properly con-
nected and reboot the server.
B. If option A fails to resolve the problem, reload Flash
ROM. See Appendix D.