Lantronix EPS2-100 Installation Manual - 7.2 Macintosh Services

AppleTalk Configuration

7 - 2

7.2 Macintosh Services

Before attempting to print from a Macintosh, ensure that AppleTalk and PostScript are both 

enabled on at least one service. Once the service is configured, it will appear in the Chooser in the 

same zone as the EPS. Select the service in the Chooser and complete the appropriate setup 

options. Then close the Chooser window and print a test page of text to the Macintosh service.

7.3 AppleTalk Zones

If there is a router on the network, the EPS will appear in the default zone specified by the router. 

To change the default zone use the Define Protocol AppleTalk Zone command. 

If the EPS is attached to a network without an AppleTalk router, all AppleTalk devices (including 

the EPS) will appear in the default zone in the Chooser.

NOTE: If no router is present on the network, the EPS will not accept AppleTalk 

print jobs for 60 seconds after booting.