Lantronix EPS2-100 Installation Manual - 6 - Lat Configuration

LAT Configuration

6 - 1

6 - LAT Configuration

The EZWebCon configuration software is the easiest way to configure the EPS. The following 

sections cover print configuration methods for LAT hosts.

NOTE: The Server needs an IP address before you can use EZWebCon. See 

the Setting the IP Address section on page 4-2 for instructions.

NOTE: To use LAT you must obtain a LAT license from your dealer or Lantronix 

and use the Set/Define Protocol LAT License command on your EPS. 

LAT print queues can be created by printing to a port or printing to a service. Printing directly to a 

port requires no EPS configuration. 

NOTE: Printing directly to a port is the easiest method for printing to the 

EPS. If you would like instructions for printing to a service, see the 

Print Server Reference Manual on the CD-ROM.