Lantronix EPS2-100 Installation Manual - page 22
of
114
TCP/IP Configuration
4 - 6
4.1.3 Using a DHCP, BOOTP, or RARP Reply
At boot time a host-based DHCP, BOOTP, or RARP server can respond to an EPS request for an
available IP address. For information about configuring the DHCP, BOOTP, or RARP server, see
your host documentation.
4.1.4 Using the Command Line Interface
1.
Connect to the serial port (Port 1) using a terminal emulation program. The serial settings
should be 9600 baud, 8 bits, 1 stop bit, no parity.
2.
Become the privileged user and enter the new IP address.
Local> SET PRIVILEGED
Password> system (not echoed)
Local>> DEFINE SERVER IPADDRESS 192.0.1.201