Vent-Axia Sentinel Kinetic B Left Installation & Commissioning Manual - page 17
Installation
Sentinel Kinetic MVHR Installation & Commissioning
17
Spigot Installation
Air entry/exit spigots may be fitted on either the top or the side of the unit for vertical or horizontal entry or exit. Attach
the spigots, depending on the space available for the ducting and orientation of the unit. Always fit the blanking caps
to the entry or exit hole not in use to ensure the correct airflow into and out of the unit.
Note: Sentinel Kinetic Plus units have spigots suitable for either diameter 150mm ducting (UK model) or for diameter
180mm ducting (rest of EU model). The diameter 180mm spigots come complete with self adhesive foam adaptors
to enable it to be used with either diameter 180mm ducting or diameter 200mm ducting. These foam adaptors are to
be fixed to the outside of the spigot for diameter 200mm ducting. High Flow units are supplied with 180mm spigots,
an accessory pack of four self adhesive foam adaptors part no. 409761 is available for use with 200mm ducting.
To move the spigots:
1. Remove the spigot by unscrewing the screw(s)
securing it to the chassis. Then pull the spigot firmly
from the entry/exit hole.
2. Remove the blanking cap by unscrewing the screw(s)
securing it to the chassis. Then pull the blanking cap
firmly from the entry/exit hole.
3. Swap over the spigot with the removed blanking cap.
4. Insert the spigot into the entry/exit hole and secure
with the retaining screw(s).
5. Insert the blanking cap into the entry/exit hole and
secure with the retaining screw(s).
N.B. Before finally fixing the unit into position it may be more convenient to make
the electrical connections; including the mains connections and any wiring
for sensor(s) or switch(es).
Wall Mounting Sentinel Kinetic & Kinetic F
1.
Refit the front and rear covers if they have been removed.
2.
Ensure the four steel wall bushes are fitted to the rear cover across the middle
and upper screws.
3.
Mark the condensate and wall bracket positions.
4.
Fit 2-off metal wall brackets (supplied) to the wall using appropriate fixings.
5.
Lift unit and locate the steel wall bushes onto the 2 wall brackets. The unit
should now be physically installed in its intended operating location.
6.
Ensure that the condensate drain is connected as described on page 15.