Vent-Axia Sentinel Kinetic B Left Installation & Commissioning Manual - page 40
Commissioning
Sentinel Kinetic MVHR Installation & Commissioning
40
Pre Heater Screen
(Currently unavailable option)
If an electrical pre heater is being used in conjunction
with the anti-frost system to prevent freezing of the
heat recovery cell then this is set to On. The pre
heater control must be wired up according to its
instructions. See Appendix 2, options and
Accessories, 407198, Anti-Frost Heater Controller.
Otherwise leave set to Off.
Note that if any sensor or other input requires the
supply fan to stop, then the heater is switched off first
and the supply fan runs on for 60 seconds before it is
switched off in order to ensure that the heater is
cooled.
Available options: Off (default) and On.
Pre Heater
Off
Dryout Screen
The Dryout screen enables the fans to be run at max
speed for a week before returning to normal operation.
This feature can help to dry out fresh plaster and paint
enabling building work to be completed more quickly.
Filters may become fouled during this time and should
be cleaned or replaced afterwards.
Available options: Off (default) and On.
Dryout
Off
Running Time Screen
The Running Time screen displays the total running
time of the unit (in hours).
No changes may be made to this screen. In the event of
power failure total time will be retained.
Running Time
12345
Filter Service
B
BMS screen
Press
and then use the
and
push-buttons to
select the time between Filter Services. The options are
Urban (6 months), Suburban (default: 12 months) or Rural
(18 months).
Filter Service
Suburban
On for BMS (default) or Off for Wired Remote Control,
automatically set up by BMS signal or Wired Remote
Control when either is plugged into BMS RJ11 socket.
BMS Mode
On
The BMS screen displays byte count and first 16 bytes
from the Building Management System (BMS) system. The
output may controlled by a BMS system to switch the unit
on or off for example in conjunction with a smoke alarm.
No changes may be made to this screen.
BMS 00