Xerox 7142 Service Manual - page 15

RJ-901C/RJ-900C 　 Maintenance Manual

1 Safety Instructions

1-3

1.3 Important Safety Instructions

General safety instructions that must be observed to use the equipment safely are explained below.

WARNING

• Do not place the plotter in the following areas. Doing so may result in the plotter tipping 

or falling over and causing injury.

• Unstable surfaces

• Angled place

• Areas subject to vibration by other equipment

• Do not stand on or place heavy objects on your plotter. Doing so may result in the plotter 

tipping or falling over and causing injury.

• Do not cover the ventilation hole of your plotter with cloth, such as a blanket or table cloth. 

Doing so could obstruct ventilation and cause fire.

• Do not place the plotter in humid and dusty areas. Doing so may result in electrical shock 

or fire.

• Make sure to use the power cable packed with the plotter you purchased. Not doing so 

may result in electrical shock or fire.

• Make sure that the following is performed before parts replacement.

• Turn off the power of the plotter.

• Remove the power cable from the power outlet.

Not doing so may cause electric shock or damage to the electric circuit.

• Unplug the cables connected to the plotter.

Failure to do so could result in damage to the plotter.