Xerox 7142 Service Manual - 7   Adjustment

RJ-901C/RJ-900C Maintenance Manual

7 Adjustment

7-1

7   Adjustment

7.1

Introduction ............................................................................................. 7- 3

7.2

Adjustment Item...................................................................................... 7- 3

7.3

Working with Dedicated Network Software.......................................... 7- 9

7.3.1 Parameter Backup .........................................................................  7-9

7.3.2 Jigs and Tools................................................................................  7-9

7.3.3 Required Environment .................................................................  7-10

7.3.4 Receiving Parameters..................................................................  7-13

7.3.5 Firmware Installation....................................................................  7-14

7.3.6 Sending Parameters ....................................................................  7-18

7.4

PF Speed Reduction Belt Tension Adjustment.................................. 7- 20

7.4.1 Jigs and Tools..............................................................................  7-20

7.4.2 Adjustment Procedure .................................................................  7-20

7.5

PF Encoder Assembly Position Adjustment ...................................... 7- 22

7.5.1 Jigs and Tools..............................................................................  7-22

7.5.2 Adjustment Procedure .................................................................  7-22

7.6

CR Belt Tension Adjustment ............................................................... 7- 24

7.7

Head Slant Adjustment (Horizontal).................................................... 7- 25

7.8

Head Slant Adjustment (Vertical) ........................................................ 7- 27

7.9

Cutter Holder Height Adjustment ........................................................ 7- 28

7.9.1 Jigs and Tools..............................................................................  7-28

7.9.2 Adjustment Procedure .................................................................  7-28