Xerox 7142 Service Manual - page 209
RJ-901C/RJ-900C Maintenance Manual
7 Adjustment
7-11
7.3.3
Required Environment
Before starting work, set up the following environment.
(1) Dedicated Network Software Startup and Plotter IP Address Check
Once "MUTOH Maintenance Engineer Assistant" is started, there is no need to exit it until a series of
processes completes.
1. Start "Mutoh Maintenance Engineer Assistant" from the shortcut on the desk top.
CAUTION
Never provide "MUTOH Maintenance Engineer Assistant" to users because the software
enables upload of plotter internal parameters to PCs.
CAUTION
For the
IP address, use the default value as much as possible. If you want to use other
IP address,
consult with the network administrator of the network to be connected.
(2) PC IP Address Setting
To set up on Windows XP with the default IP address on the plotter, follow the steps below.
1. From [Control Panel], open [Network Connections].
2. From [Setup] menu, select [Option] and check if
the displayed address matches the plotter IP
address. The default plotter IP address is
"192.168.1.253". Then, click [OK].