Xerox 7142 Service Manual - page 243
RJ-901C/RJ-900C Maintenance Manual
8 Maintenance
8-7
8.5 Transportation of Plotter
This section describes how to transport the plotter.
Before transporting the plotter, you must package it in the same manner as it was delivered using protective
materials and packaging materials so that the plotter will not be subject to excessive impact and vibrations
during the transportation.
Follow the steps below to package the plotter.
(1) Task Before Transportation
1. Turn the plotter power OFF.
2. Verify that the plotter is in normal state.
3. Remove all ink cartridges.
4. Turn off the plotter.
5. The operation panel shows “Transport Mode” and the plotter begins ink discharging operation.
6. It takes about two minutes for discharging ink.
7. Check that ink discharging is complete and the Power lamp is off.
8. Remove the scroller.
9. Remove all cables including the power cable.
10. Fit the plotter with protective materials.
TIP
Operation manual
11. If the optional stand is used, separate the plotter from the stand.
TIP
Operation manual
12. Package the plotter.
(2) Task After Transportation
1. Unpack, assemble, and install the plotter.
2. Make the plotter ready for operation.