Xerox 7142 Service Manual - page 184
5 Self-Diagnosis Mode
RJ-901C/RJ-900C Maintenance Manual
5-66
5.9.5
Pump Endurance Menu
This menu performs endurance running for the pump motor assembly.
In this menu, pump motor can be driven according to the value set. The available settings are shown below.
TIP
• If the number of endurance running cycles is set to -1, the carriage continuously repeats endurance
running until cancel input is given from the operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If
the number of cycles exceeds the maximum value, the counter is reset to 0.
Table 5-20 Set Items in Pump Motor Assembly Endurance Menu
Set item
Contents
Set value
Remark
Running speed
Set the running speed of
pump motor assembly.
Super High / High /
Normal
Number of endurance
running cycles
Set the number of endurance
running cycles
-1 to 10000
Previous menu
Previous menu
Next menu
Previous menu
Next menu
Previous menu
Next menu
Next menu
[Enter]
key
[Enter]
key
[Enter] key
[Enter] or [Cancel ] key
[Enter]
key
Endurance Count
Performing Endurance