Xerox 7142 Service Manual - page 276
9 Troubleshooting
RJ-901C/RJ-900C Maintenance Manual
9-32
9.2.6
Error Messages During File Transmission
This section describes the error messages displayed when sending backup parameters and firmware using
dedicated online software, as well as their recovery actions.
Table 9-8 Error Messages During File Transmission
No.
Message
Event/
symptom
Check item
Action
Reference
1
Transfer failed
Data format
error
Firmware data
format is
inappropriate.
Check if transferred
firmware is an
appropriate file.
After confirming it,
install firmware again.
"7.3.5
Firmware
Installation"
p.7-15
2
Transfer failed
Aborted by the
HOST
Cancel button
on PC has been
pressed.
-
Transfer firmware
again.
3
Transfer failed
Data timeout
Communication
time-out
occurred.
Check connection
between plotter and PC.
After resolving
problem, transfer
firmware again.
4
Transfer failed
Check-sum
error
File checksum
error.
-
1. Transfer firmware
again.
2. If error message is
still displayed,
check if transferred
firmware is an
appropriate file.
5
Transfer failed
Incompatible
F/W
Incompatible
firmware.
Check if program file is
appropriate.
After confirming it,
install firmware again.
"7.3.5
Firmware
Installation"
p.7-15
6
Transfer failed
Flash erase
error
ROM erase
error.
Board may be defective. Replace board.
"4.3.3
Replacing
Main Board
Assembly"
p.4-21
7
Transfer failed
Flash write
error
ROM writing
error.
8
Transfer failed
Flash compare
error
ROM writing
error.
9
Transfer failed
Flash error FFF
ROM writing
error.