Xerox 7142 Service Manual - page 327
RJ-901C/RJ-900C Maintenance Manual
10 Appendix
10-3
10.4 Jigs and Tools
This section provides lists of jigs and tools required for service operations.
10.4.1 Required Tools
(1) Tools for Part Replacement
(2) Tools for Adjustment
Table 10-2 Tools for Part Replacement
No.
Name
Part number
Remarks
1
Phillips driver No.2
Generic product
More than 250mm shaft length is
recommended
2
Phillips driver No.2
Generic product
Less than 50mm shaft length is
recommended
3
Phillips driver No.1
Generic product
4
Flat-head driver
Generic product
5
Longnose plier
Generic product
6
Tweezers
Generic product
7
Hex wrench (opposite side:
6mm)
Optional stand
accessory (Generic
product)
Required only when disassembling legs
Table 10-3 Tools for Adjustment
No.
Name
Part number
Remarks
1
Personal computer
Generic product
2
Tension gauge
Generic product
Max. 10,000gf (100N) for measurement
3
Tension gauge
Generic product
Max. 4,000gf (40N) for measurement
4
A4 matte film
"Dia mat super A4"
manufactured by
Kimoto Co.,Ltd
Used for media sensor adjustment
(P_REAR sensor and P_EDGE sensor)
5
Coated paper
Exclusive use media For plot quality adjustment
6
Straight scale (1000mm)
Generic product