Xerox DocuPrint 4635 User Interface Reference - page 144
SYSTEM CONTROL WINDOWS
percentage will be reset to 86% if the session is restarted or if
Audit Logs are deleted and the disk is less than 86% full. If Audit
Logs are deleted and the disk is still more than 86% full, the
current disk full percentage is saved as the starting percentage.
If the “Continue“ button is selected followed by selection of the
Apply/Close header button, the printer continues. The printer
does not actually stop despite the fact that the disk is
approaching full.
If the “Audit Log Administration“ button is selected followed by
selection of the Apply/Close header button, the Audit Log
Administration window will open. This will allow the deletion of
information on the disk.
When the Audit Log disk is full, the same window will appear but
the message will read:
“The Audit Log hard disk is FULL and audit data has been
lost. All incoming audit data will be lost until unneeded
Audit Logs have been deleted.”
The printer will be sent a STOP command and will stop after all
in-process sheets are delivered. All audit data from the time the
audit disk became full until the printer stops will be lost. Audit
logging stopped when the disk became full and cannot continue
until space becomes available. The “Continue” header button on
the window will be unavailable and the user must open the Audit
Log Administration window and delete unneeded logs from the
disk. Only the Audit Log Administration window and windows
called up through it will be available until the user closes the
Audit Log Administration window after making space on the hard
disk. Unless the user deletes unneeded logs from the hard disk,
all audit data will be lost.
Defaults . . . - Selecting this header button of the Audit Log
Administration window enables the user to set defaults for the
Audit Log through the Audit Log Defaults window.
8-32
XEROX 4635 LASER PRINTING SYSTEM PC USER INTERFACE REFERENCE