Yamaha YZF-R1S Service Manual - Chas
4-14
REAR WHEEL AND BRAKE DISC
CHAS
NOTE:
150 Nm (15 m
Skg, 108 ftSlb)
27 Nm (2.7 m
Skg, 20 ftSlb)
22 Nm (2.2 m
Skg, 16 ftSlb)
NOTE:
2. Replace:
Srear wheel sprocket
a. Remove the self-locking nuts and the rear
wheel sprocket.
b. Clean the rear wheel drive hub with a clean
cloth, especially the surfaces that contact the
sprocket.
c. Install the new rear wheel sprocket.
Rear wheel sprocket self-locking
nut
100 Nm (10 m
Skg, 72 ftSlb)
Tighten the self-locking nuts in stages and in a
crisscross pattern.
EAS00572
INSTALLING THE REAR WHEEL
1. Lubricate:
Swheel axle
Swheel bearings
Soil seal lips
Recommended lubricant
Lithium-soap-based grease
2. Tighten:
Swheel axle nut
Sbrake caliper bolts (front)
(rear)
EAS00575
ADJUSTING THE REAR WHEEL STATIC
BALANCE
SAfter replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
SAdjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
1. Adjust:
Srear wheel static balance
Refer to “ADJUSTING THE FRONT WHEEL
STATIC BALANCE”.