Yamaha YZF-R1S Service Manual - Chas
4-54
FRONT FORK
CHAS
NOTE:
WARNING
d. Press down on the spacer with the fork
spring compressor
1
.
e. Pull up the rod puller and install the rod hold-
er
2
between the nut
3
and the spacer
4
.
Use the side of the rod holder that is marked “B”.
Fork spring compressor
90890-01441, YM-01441
Rod holder
90890-01434, YM-01434
f. Remove the rod puller and adapter.
g. Install the nut
1
and position it as specified
b
.
Distance
b
11 mm (0.43 in)
h. Set the cap bolt distance
c
to specification.
Distance
c
13 mm (0.51 in)
i. Install the damper adjusting rod and cap bolt,
and then finger tighten the cap bolt.
j. Hold the cap bolt and tighten the nut to speci-
fication.
Nut
15 Nm (1.5 m
Skg, 11 ftSlb)
k. Remove the rod holder and fork spring com-
pressor.
SThe fork spring is compressed.
SAlways use a new cap bolt O-ring.