Yamaha YZF-R1S Service Manual - Chas
4-59
HANDLEBARS
CHAS
NOTE:
CAUTION:
NOTE:
NOTE:
NOTE:
2. Install:
Sright handlebar switch
1
Align the projection
a
on the right handlebar
switch with the hole
b
in the right handlebar.
3. Install:
Sbrake master cylinder holder
1
SInstall the brake master cylinder holder
with the “UP” mark facing up.
SFirst, tighten the upper bolt, then the lower
bolt.
SAlign the mating surfaces of the brake master
cylinder holder with the punch mark
a
in the
right handlebar.
SThere should be 2 mm (0.08 in) of clearance
between the right handlebar switch and the
brake master cylinder holder.
4. Install:
Sthrottle grip
Sthrottle cable housing
1
Sthrottle cables
Align the projection
a
on the throttle cable
housing with the hole
b
in the right handlebar.
5. Install:
Sclutch lever holder
1
Align the slit in the clutch lever holder with the
punch mark
a
in the left handlebar.