Yamaha YZF-R1S Service Manual - page 361
7-17
Intake air pressure sensor output
voltage
3.75
X 4.25 V
Tester positive probe
! pink/white
Tester negative probe
! black/blue
1
2
FUEL INJECTION SYSTEM
FI
Fault code No.
13
Symptom
Intake air pressure sensor – open or short circuit detected.
Used diagnostic code No. 03 (intake air pressure sensor)
Order
Inspection operation item and probable
cause
Operation item and countermeasure
Reinstatement
method
1
Connected condition of connector
Inspect the coupler for any pins that
may have pulled out.
Check the locking condition of the
coupler.
If there is a malfunction, repair it and connect it
securely.
Intake air pressure sensor coupler
Main wiring harness ECU coupler
Sub-wire harness coupler
Reinstated by
turning the
main switch
ON.
2
Open or short circuit in wiring harness
and / or sub lead.
Repair or replace if there is an open or short
circuit.
Between sensor coupler and ECU coupler
Black / Blue – Black / Blue
Pink / White – Pink / White
Blue – Blue
3
Defective intake air pressure sensor
Execute the diagnostic monitoring mode (Code
No.03).
Replace if defective.
1. Connect the pocket tester (DC 20 V) to the
intake air pressure sensor coupler terminal as
shown.
2. Set the main switch to “ON”.
3. Measure the intake air pressure sensor output
voltage.
4. Is the intake air pressure sensor OK?