Yamaha YZF-R1S Service Manual - Eng
5-88
CONNECTING RODS AND PISTONS
ENG
8 Nm (0.8 m
Skg, 5.8 ftSlb)
NOTE:
NOTE:
29.4 Nm (3.0 m
Skg, 21 ftSlb)
NOTE:
6. Check:
Scylinder stud bolts
1
7. Install:
Scylinder gasket
2
New
8. Install:
Sbig end bearings
(onto the connecting rods and connecting
rod caps)
SAlign the projection
a
on the big end bearings
with the notches
b
in the connecting rods and
connecting rod caps.
SBe sure to reinstall each big end bearing in its
original place.
SMake sure that the characters
c
on both the
connecting rod and connecting rod cap are
aligned.
9. Tighten:
Install by carrying out the following procedures
in order to assemble in the most suitable condi-
tion.
Sconnecting rod bolts
SFirst, tighten the bolts to 15 Nm (1.5 mSkg, 11
ft
Slb).
SRetighten the bolts to 29.4 Nm (3.0 mSkg, 21
ft
Slb).
a. Replace the connecting rod bolts with new
ones.