Yamaha YZF-R1S Service Manual - page 363
7-19
FUEL INJECTION SYSTEM
FI
Fault code No.
15
Symptom
Throttle position sensor – open or shrt circuit detected.
Used diagnostic code No. 01 (throttle position sensor)
Order
Inspection operation item and probable
cause
Operation item and countermeasure
Reinstatement
method
1
Installed condition of throttle position
sensor.
Check the installed area for looseness or
pinching.
Check that it is installed in the specified
position.
Refer to “THROTTLE BODIES” section.
Reinstated by
turning the
main switch
ON.
2
Connected condition of connector
Inspect the coupler for any pins that
may have pulled out.
Check the locking condition of the
coupler.
If there is a malfunction, repair it and connect it
securely.
Throttle position sensor coupler
Main wiring harness ECU coupler
Sub-wire harness coupler
3
Open or short circuit in wiring harness
and / or sub lead.
Repair or replace if there is an open or short
circuit.
Between sensor coupler and ECU coupler
Black / Blue – Black / Blue
Yellow – Yellow
Blue – Blue
4
Throttle position sensor lead wire open
circuit output voltage check.
Check for open circuit and replace the throttle
position sensor.
Black / Blue – Yellow
Open circuit item
Output voltage
Ground wire open
5 V
circuit
Output wire open
0V
circuit
Power supply wire
0V
open circuit
5
Defective throttle position sensor.
Execute the diagnostic mode (Code No.01).
Replace if defective.
Refer to “THROTTLE BODIES” section.
Fault code No.
16
Symptom
Stuck throttle position sensor detected.
Used diagnostic code No.01 (throttle position sensor)
Order
Inspection operation item and probable
cause
Operation item and countermeasure
Reinstatement
method
1
When detecting fault code No.15.
Refer to “Fault code No.15”.
Reinstated by
2
Installed condition of throttle position
sensor.
Check the installed area for looseness or pinching.
Check that it is installed in the specified position.
Refer to “THROTTLE BODIES” section.
starting the
engine,
operating it at
idle and then
3
Defective throttle position sensor
Execute the diagnostic mode (Code No.01).
Replace if defective.
Refer to “THROTTLE BODIES” section.
idle, and then
racing it.