Yamaha YZF-R1S Service Manual - Chas
4-60
HANDLEBARS
CHAS
NOTE:
WARNING
6. Install:
Sleft handlebar switch
1
Align the projection
a
on the left handlebar
switch with the hole
b
in the left handlebar.
7. Install:
Shandlebar grip
a. Apply a thin coat of rubber adhesive onto the
end of the left handlebar.
b. Slide the handlebar grip over the end of the
left handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
8. Adjust:
Sclutch cable free play
Refer to “ADJUSTING THE CLUTCH
CABLE FREE PLAY” in chapter 3.
Clutch cable free play
(at the end of the clutch lever)
10
X 15 mm (0.39 X 0.59 in)
9. Adjust:
Sthrottle cable free play
Refer to “ADJUSTING THE THROTTLE
CABLE FREE PLAY” in chapter 3.
Throttle cable free play
(at the flange of the throttle grip)
3
X 5 mm (0.12 X 0.20 in)
CHECKING THE STEERING DAMPER
1. Check:
Ssteering damper body
Damage / oil leaks
! Replace.
(It replace with the assembly.)
Ssteering damper rod
Bends / scratch
! Replace.
(It replace with the assembly.)
Sbearing
Damage /pitting
! Replace.
(It replace with the assembly.)