4RF Aprisa SR+ User Manual - page 275
Managing the Radio | 273
Aprisa SR+ User Manual 1.5.3
Protected Station: Terminal > Operating Mode > MMS
This screen applies when the terminal is a Migration Master Station.
MIGRATION MASTER STATION
Maximum CTS Wait Duration (ms)
This parameter sets the maximum delay between applying the key-up signal and sending serial data to the
legacy radio. If CTS signal is detected before the delay expires, then the serial data is sent immediately.
The default setting is 0 ms.
Preferred Network
This parameter sets the Preferred Network to Legacy or Aprisa. The network will be switched to this
selection when the Preferred Network Auto Revert Idle time expires i.e. it is the rest state for the switch.
Setting this parameter to the predominant network can reduce latency. The default setting is Aprisa.
Preferred Network Auto Revert Idle (ms)
This parameter sets the amount of time after the previous serial poll response or timeout to wait before
switching to the preferred network. The default is 300ms.
Network Response Delay (ms)
This parameter sets the maximum amount of time after a transmit is completed before the first byte of a
response packet is expected. The default setting is 1000 ms.