4RF Aprisa SR+ User Manual - page 87
Managing the Radio | 85
Aprisa SR+ User Manual 1.5.3
Repeater Network Segment ID
This parameter identifies a repeater network segment and its associated remotes.
In an overlapping coverage network where remote radios can ‘see’ multiple repeaters, it’s especially
important to set different values for each repeater network segment and its associated remotes, so the
associated remotes will communicate only with the appropriate repeater.
The same setting applies in remote overlapping coverage between a base and a repeater. Different values
per base and repeater are required if the requirements are that the remote will be communicating via the
repeater and not directly with the base station (or vice-versa), i.e. the repeater and remotes will have the
same value but different from the base station value. In this case, if the repeater fails, the remote will re-
register to the base station even though they are on different values until the repeater recovers.
The entry is an integer from 0 and 31, where 0 is reserved for broadcast i.e. all radios will ‘see’ this radio
traffic even if they are set to different values.
Inband Management
This parameter displays the status of the Inband Management option.
Inband Management Timeout (sec)
This parameter displays the number of seconds that the base station waits for a response from a Remote
or repeater station before aborting the Inband Management request.