4RF Aprisa SR+ User Manual - page 50
48 | Implementing the Network
Aprisa SR+ User Manual 1.5.3
Initial Network Deployment
Install the Base Station
To install the base station in your network:
1. Install the base station radio (see ‘Installing the Radio’ on page 58).
2. Set the radio Network ID to a unique ID in your entire network (see ‘Terminal > Device’ on page 88).
3. Set the radio operating mode to ‘base station’ (see ‘Terminal > Operating Mode’ on page 94).
4. Set the radio IP address (see ‘
.
5. Set the radio frequencies to the frequencies you wish to operate from (see ‘Radio > Radio Setup’ on
page 99).
6. Set the radio security settings (see ‘Security > Setup’ on page 171).
Installing the Remote Stations
To install the remote stations in your network:
1. Install the remote station radio (see ‘Installing the Radio’ on page 58).
2. Set the radio Network ID to the same ID as the other stations in the network (see ‘Terminal > Device’
on page 88).
3. If repeater used in radius 1, set the network radius=2 on all network stations (see ‘Terminal > Device’
on page 88).
4. Set the radio operating mode to ‘remote station’ (see ‘Terminal > Operating Mode’ on page 94).
5. Set the radio IP address (see ‘IP > IP Setup > Bridge / Gateway Router Modes’ on page 141).
6. Set the radio frequencies to the base station / repeater station frequencies you wish to operate from
(see ‘Radio > Radio Setup’ on page 99).
7. Set the radio security settings to the same as the base station (see ‘Security > Setup’ on page 171).
The base station will automatically allocate a node address to the new remote station.
Install a Repeater Station
To install a repeater station in your network:
1. Install the repeater station radio (see ‘Installing the Radio’ on page 58).
2. Set the radio Network ID to the same ID as the other stations in the network (see ‘Terminal > Device’
on page 88).
3. Increase the radio network radius by one on all stations in the network (see ‘Terminal > Device’ on
page 88).
4. Set the radio operating mode to ‘repeater station’ (see ‘Terminal > Operating Mode’ on page 94).
5. Set the radio IP address (see ‘IP > IP Setup > Bridge / Gateway Router Modes’ on page 141).
6. Set the radio frequencies to base station frequencies you wish to operate from (see ‘Radio > Radio
7. Set the radio security settings to the same as the base station (see ‘Security > Setup’ on page 171).
The base station will automatically allocate a node address to the new repeater station.