4RF Aprisa SR+ User Manual - page 51
Implementing the Network | 49
Aprisa SR+ User Manual 1.5.3
Network Changes
Adding a Repeater Station
To add a repeater station to your network:
1. Install the repeater station radio (see ‘Installing the Radio’ on page 58).
2. Set the radio Network ID to the same ID as the other stations in the network (see ‘Terminal > Device’
on page 88).
3. Set the radio IP address (see ‘IP > IP Setup > Bridge / Gateway Router Modes’ on page 141).
4. Set the radio frequencies to the base station frequencies you wish to operate from (see ‘Radio > Radio
5. Set the radio operating mode to ‘repeater station’ (see ‘Terminal > Operating Mode’ on page 94).
6. Increase the radio network radius by one on all stations in the network (see ‘Terminal > Device’ on
page 88).
The base station will automatically allocate a node address to the new repeater station.
To remove a repeater station from your network:
1. Turn the power off on the remote station radios operating from the repeater station radio you wish to
remove.
2. Turn the power off on the repeater station radio you wish to remove.
3. Decrease the network radius by one on all stations in the network (see ‘Terminal > Device’ on page
Adding a Remote Station
To add a remote station to your network:
1. Install the remote station radio (see ‘Installing the Radio’ on page 58).
2. Set the radio Network ID to the same ID as the other stations in the network (see ‘Terminal > Device’
on page 88).
3. If repeater used in radius 1, set the network radius=2 on all network stations (see ‘Terminal > Device’
on page 88).
4. Set the radio IP address (see ‘IP > IP Setup > Bridge / Gateway Router Modes’ on page 141).
5. Set the radio frequencies to the base station / repeater station frequencies you wish to operate from
(see ‘Radio > Radio Setup’ on page 99).
6. Set the radio operating mode to ‘remote station’ (see ‘Terminal > Operating Mode’ on page 94).
The base station will automatically allocate a node address to the new remote station.
To remove a remote station from your network:
1. Turn the power off on the remote station radio you wish to remove. This is the only action that is
required.
Note
: The remote station will continue to show in the Network Table list.