4RF Aprisa SR+ User Manual - page 359
Product Options | 357
Aprisa SR+ User Manual 1.5.3
Cabling
The Aprisa SR+ Migration Switch is delivered with rack mounting hardware and interconnect cables and
adaptors. This includes:
2x 4G0200-4053A01
cable TNC to TNC 160 mm RG142
2x 4G0200-4054A02
cable N-male to N-male 360 mm RG142
2x 4G0200-4055A00
cable N-female to TNC 800 mm RG142
2x 4G0200-4004A02
cable RJ45 to RJ45 flat 185 mm black
1x 4G0200-0109A00
cable RJ45 to RJ45 1.5 m black
1x 4G0200-0117
cable RJ45 to RJ45 1.5 m grey
1x 4G0400-0043A01
adapter RJ45 to DB25 female
1x 4G0400-0044A00
adapter RJ45 TO DB25 male
The MMS standard cabling is as follows:
The two RJ45 to RJ45 flat 185 mm black cables connect the Alarms ports from the Aprisa SR+
Protected Station to the Migration Switch.
The RJ45 to RJ45 1.5 m black and grey cables connect the traffic interfaces from the SCADA
master and the legacy master via the Migration Switch cable channel.
The TNC to TNC 160 mm RF cables connect the antenna ports between the Aprisa SR+ Protected
Station A / B TNC connectors and the Migration Switch APRISA MASTER TNC connectors.
For single antenna operation, a cable between the TX / ANT connectors is required.
For dual antenna operation, a cable between the TX / ANT connectors is required and a cable
between the RX connectors is required.
The N-male to N-male 360 mm RF cables connect the antenna ports between the legacy master
and the Migration Switch (rear panel connectors).
The N-female to TNC 800 mm RF cable connects the antenna to the Migration Switch ANT / DUP
TNC connectors.
For single antenna operation, a cable between the antenna and the ANT / DUP > TX / ANT TNC
connector.
For dual antenna operation, a cable between the external duplexer TX and the ANT / DUP > TX /
ANT TNC connector and a cable between the external duplexer RX and the ANT / DUP > RX TNC
connector.