Abekas Mira User's Operation Manual - page 220
User Operations Guide—Mira Instant Replay Server
218
Copyright ©2014, Abekas Incorporated
Revised: 5 September 2014
Engineering Setup — RS422
The RS422 tab in the Mira Engineering Setup menu is used to assign RS422 serial control protocol and customized parameters to one of
16 “Rooms”; and then you can assign that “Room” to any of the video channel RS422 serial control ports.
To open the Mira Engineering Setup window shown below, perform the procedure “Launching Mira Engineering Setup Utility” found on page 173 above.
1.Click “RS422” tab.
2.Click “Room x Configuration” pull-down and select
desired “Room #” you wish to configure.
3.Click radio button for desired RS422 protocol.
4. Optional: Adjust Edit Timing parameters
(see explanations on next page).
5. Optional: Adjust Protocol Configuration parameters
(see explanations on next page).
6.Repeat steps (2) thru (5) above for any additional
“Rooms” you wish to configure.
7.Assign configured “Room” to desired RS422 serial
control port, using Port pull-downs.
(Port 1 = ChA); (Port 2 = ChB); etc.
8.Click
button.
The Restart Mira window appears:
The next step will unload & reset ALL video channels!
9.Click
(shown above).
Restart progress is displayed; finishes in 10-15 seconds:
10.Click
in Restart Mira window.
This will close the Restart Mira window.
Continued on next page…
9
1
2
7
3
4
5
6
8
10