C-Nav 2050M User Manual - page 3
of
166
C-Nav2050 User Guide
Quick Start Guide
Hardware Connect
1. Connect the supplied LEMO 7-pin connector of
the serial cable to COM2 of the C-Nav2050.
Connect the DB9S end to the PC (or other
controller device).
2. Connect the supplied LEMO 7-pin connector of
the dual data cable to COM1 of the C-Nav2050.
Connect the DB9 ends as required. A typical
setup could include: NMEA data-out to the
Navigation or DP (Dynamic Positioning) System,
and data-in from a 3
rd
party connection input
(RTCM)
Antenna Mount
TNC Connector
3. Mount the supplied antenna to the mast, as
described in Chapter 3. (Ensure the antenna is
in an area with a 360° view of the sky.
i