C-Nav 2050M User Manual - page 76
of
166
C-Nav2050 User Guide
Factory Default Settings
COM1
Factory Default Configuration - Data port
Rate – 19.2Kbps
Output of NMEA messages GGA & VTG set @
1Hz*
COM1 is the factory default data port and manages the
non-NCT binary proprietary messages that are input
and/or output to/from the receiver.
The user has full control over the utilized message
types and their associated rates via either C-Setup, C-
Monitor
,
C-NaviGator, StarUtil or a third party
software/utility.
*Though the output rate defaults to 1Hz, the data output
rate can be changed to On Change in StarUtil. Making
this selection in the NMEA output list will better reflect
the navigation rate selected in the Rover Setup screen.
Figure 27: StarUtil NMEA Message List
4-2