C-Nav 2050M User Manual - page 55
of
166
C-Nav2050 User Guide
The Link LEDs are software configurable
via the x3f proprietary command.
Base LEDs
Table 6: Base Station Indication
BASE Status
The BASE LEDs are not utilized in C-Nav
Correction Service operating mode
The following LEDs reflect the type of RTK
corrections when the C-Nav2050 is operated as a
Base Station
RTK/UltraRTK™ - NCT Proprietary
(1Hz blink rate)
CMR (1Hz blink rate)
RTCM 18, 19 (1Hz blink rate)
20, 21 (5Hz blink rate)
GPS LEDs
Table 7: GPS Light Indication
GPS Status
Power is off
Power is on, No satellites tracked
Tracking satellites, position not available yet
Non-differential positioning
Code based differential positioning
Dual frequency Phase positioning
2-13