C-Nav 2050M User Manual - page 4
C-Nav2050 User Guide
4. Connect a GPS antenna cable to the TNC
connector of the GPS antenna. Connect the
other end to the TNC connector, labeled GPS
ANT on the receiver.
5. C-Nav2050R Only: To track C-Nav Correction
Service signals at high latitudes, mount the L-
band antenna to a mast as described in Chapter
3. Connect a GPS antenna cable to the L-band
antenna. Connect the other end to the second
TNC connector on the front of the receiver,
labeled L-BAND ANT (See p. 4).
6. Select the power cord appropriate for your
region and attach to the power adaptor. Connect
the power cord to the available power source,
OR, connect a DC power source (12V nominal)
to the C-Nav2050 power cable. Refer to Figure 6
for power cable pin assignments.
7. Connect the supplied LEMO 4-pin power cable
to the connector, labeled DC PWR on the front
of the receiver.
8. Depress the On/Off switch on the front panel for
more than 3 seconds to power on the receiver.
All LEDs illuminate for 3-5 seconds during
power-up.
9. Your C-Nav2050 hardware is now properly
connected.
ii