C-Nav 2050M User Manual - page 81
of
166
C-Nav2050 User Guide
2. Ensure that the follo
(minimum) are enabled for output from the
Control Port (On Change):
0x44 - Almanac
0x81 - Ephemeris
0x86 - Channel Status
wing NCT 'binary' messages
lection
0xA0 - Alerts
0xB0 - Raw Measurements
0xB1 - Solution
0xB2 - Satellite Se
0xE1 - Failure Details
0x5F, 0x60, 0xD3 (LBM DSP Status), from the
LBM Status Menu. (Receiver Setup
StarFire Configure Message Output)
ure 30: NCT Binary Message Output Configuration
Fig
the
ata
se a logging file name of:
‘serial number of receiver.dat'
3. Using the StarUtil data logging utility, enable
logging schedule and log the RAW 'binary' d
to a file. U
4-7