Cannondale ATV Owner's Manual - page 105
Manual is about: 2002
of
180
103
2. Inspect the brake discs for bending, chips, cracks, deep
wear grooves, or other damage. Slight circumferential
grooving is indicative of normal wear, and does not
necessitate replacing the brake disc. However, if the
brake disc is worn beyond the specified thickness it
must be replaced.
3. Make sure the front and rear brake disc mounting bolts
are tightened to the specified torque.
1. Front brake pads (right) wear limit indicator
2. Banjo bolt
a. Disc thickness
NOTE :
Remove the front wheel to check the front pads.
1
2
a
1. Rear brake pads wear limit indicator
2. Banjo bolt
3. Rear disc mounting bolt (1 of 4 visible in photo)
a. Disc thickness
3
a
2
1