Cannondale ATV Owner's Manual - page 90
88
5. Place a container under engine oil filter cover and
remove the bolt, engine oil filter cover and the two cover
O-rings.
6. Remove the engine oil filter seal, oil filter and oil filter
seal from the housing. Wipe the inside of the filter
housing with a clean shop towel to remove any
accumulated sediments or other debris.
7. If your filter is the screen type, clean the filter using
compressed air. If your filter is the paper element type,
discard it and replace it with a new one.
8. Inspect the seals and filter element for tears, cracks,
and other damage. Replace if damaged.
9. Apply a light coat of O-ring grease to the large and
small cover O-rings and insert them back into the
cover.
1. Bolt
2. Cover
1
2
1. Bolt
2. Cover
3. O-ring
4. O-ring
5. Filter seal
6. Filter (screen)
(1)
(2)
(3)
(4)
(6)
(5)
(5)