Cannondale ATV Owner's Manual - Break-In
67
BREAK-IN
The break-in period is critical to the long term life and
reliability of the engine. The break-in period for the engine
is 1 hour. When operating during this period be sure to
observe the following cautions:
•
Ride at low to medium engine speeds.
•
Do not lug or rev the engine during the break-in
period.
•
Avoid full-throttle starts and rapid acceleration.
•
Do not hold the throttle grip in one position for
more than a few seconds. It is better to roll the
throttle on and off and ride on flat terrain.
•
Avoid riding up steep hills and in sand because
this produces greater engine loads, possibly
damaging engine components.
1. Ride the ATV normally for two 10-minute segments
using no more than 1/2 throttle. Wait for the engine to
cool completely between segments.
2. Next, ride three 15-minute segments using no more
than 3/4 throttle, again allowing the engine to cool
between rides.
NOTE :
During all rides, it is important to shift gears often so
that high rpms are avoided and the engine is not
lugged.
3. After riding the vehicle, clean it thoroughly and allow it
to dry. Then inspect the entire vehicle for damage or
loose fasteners.
4. Repair or tighten any damaged or loose components
and lubricate the vehicle.
5. If the vehicle is damaged, it is recommended that
you put tape over the start button to remind you to
not start the vehicle. Also, attach a piece of paper to
the handlebar with the problem written on it.
6. Complete the break-in period maintenance
schedule. See “Maintenance & Adjustment” starting
on page 68.