Cannondale ATV Owner's Manual - page 91

89

NOTE : 

Use some O-ring grease to “stick” the filter seals so that

they are centered on the filter. This will help assure that

the seals remain in place when you insert the filter into

the housing.

10.  Install the cover and cover bolt. Tighten the bolt to

the specified torque.

CAUTION

Do not over-tighten the cover bolt. You will damage

the threads of the filter housing. If the cover leaks,

you may need to replace the cover O-rings or

inspect the cover and housing mating surfaces for

damage.

11. Now, carefully work the heat shield back to expose the

left spar return hose and clamp. Then, remove the

clamp and hose from the engine oil inlet fitting.

1. Heat shield

2. Spar return hose

3. Clamp

4. Inlet fitting

(1)

(2)

(3)

(4)