Cannondale ATV Owner's Manual - page 121
119
Chain guide block inspection
Check the drive chain guide block for excessive wear,
cracks, and/or any other damage. Make sure it is fastened
securely to the swingarm. If the guide block is damaged or
worn, replace it with a new one.
Chain slack inspection
NOTE :
Clean and lubricate the drive chain before measuring
the slack. The chain’s condition affects the accuracy of
measurement. Also, when measuring, rotate the chain
and measure different links at the mid-point between
the sprockets.
1. Place the vehicle on a level surface with all four wheels
on the ground.
2. Measure the slack (a) at the middle point between the
sprockets from the top of the swingarm to the bottom of
the links. Adjust if out of specification.
1. Guide block
2. Bolts
1
2
a. Chain slack
a