Cannondale ATV Owner's Manual - page 98

96

Checking the coolant level

1. Make sure the engine and radiator are completely cold.

2. Remove the right headlight cover and observe the

coolant level in the bottle without opening the cap. The

level should be at the ‘LEVEL’ mark. 

Adding coolant

1. To add coolant, make sure the engine is cold.

2. Place a thick rag over the coolant bottle cap and open it

very slowly to allow any residual pressure to escape.

Then, remove the cap and slowly add the specified

coolant using a clean funnel until it reaches the ‘LEVEL’

mark.

3. Reinstall the cap and check coolant system for leaks.

Changing the coolant

CAUTION

Bleed the coolant system after refilling.

1. Make sure the coolant system is completely cold and

you are wearing safety glasses and protective rubber

gloves. Have a few clean rags handy to wipe up any

spills.

2. Place a thick towel over the coolant bottle cap and

remove the cap slowly to release any residual pressure.

1. “LEVEL’ mark

2. Cap

1

2