Cannondale ATV Owner's Manual - page 115
113
Setting the clutch release collar with a hydraulic
clutch system
Complete the following procedure anytime the clutch
plates or springs are replaced.
1. Remove the shift lever and clutch cover.
2. Loosen the clutch release collar lock nut.
3. Turn the adjuster locknut all the way in (clockwise).
Then back the adjuster out (counterclockwise) three full
turns.
4. Tighten the adjuster locknut to the specified torque.
5. Check the fluid level in the master cylinder.
Clutch arm adjustment (manual)
Normal clutch plate wear and cable stretch influences
the clutch arm position. If the length (a) is out of
specification, you will need to adjust it.
NOTE :
A special “clutch release collar” holding tool has been
developed for the following procedure, but right angle
circlip plier of the correct size can be used successfully.
Contact an authorized Cannondale dealer for
information on special tools for your vehicle.
a. length
(a)