Cannondale ATV Owner's Manual - page 96
94
3. If the filter did not come out with the bolt, remove it
carefully from the hole. Clean it using compressed air.
4. Inspect the filter for cracks, holes, tears, and other
damage. Replace new if damaged.
5. Make sure the threads of the bolt and crankcase are
clean.
6. Apply anti-seize compound to the threads of the
transmission drain bolt (1). The sealing washer is
reusable, however, inspect its condition before
reinstalling. A damaged washer may result in a fluid
leak. Install the washer onto the bolt so that the flat side
(a) faces the case. Insert the filter into the bolt, and
install into the case.
7. Tighten the bolt to the specified torque.
8. Add the specified transmission oil at the filler cap until
the oil level reaches the bottom of the check bolt hole.
Pour slowly and allow time for the oil to flow throughout
the case cavity.
9. Then, run the engine briefly (1-2 minutes) to circulate
newly added oil and recheck the level. Add if necessary.
1. Filter
(1)
1. Drain bolt
2. Sealing washer
3. Filter (screen)
a. Sealing washer flat side
(1)
(2)
(a)
(3)