D-Link DES-3350SR User Manual - page 107
D-Link DES-3350SR Standalone Layer 3 Switch
97
To enter an IP Interface into the Switch’s Static/Default Route Settings window, click the Add button, revealing the following
window to configure.
Figure 9 - 8. Routing Table – Add window
The following fields can be set:
Parameters Description
IP Address
Allows the entry of an IP address that will
be a static entry into the Switch’s Routing
Table.
Subnet Mask
Allows the entry of a subnet mask
corresponding to the IP address above.
Subnet Mask
Allows the entry of a subnet mask
corresponding to the IP address above.
Cost(1-65535)
Allows the entry of a routing protocol
metric representing the number of
routers between the Switch and the IP
address above.
Backup Status
The user may choose between Primary
and Backup. If the Primary Static/Default
Route fails, the Backup Route will
support the entry. Please take note that
the Primary and Backup entries cannot
have the same Gateway.
Click Apply to implement changes made.
Static ARP Settings
The Address Resolution Protocol (ARP) is a TCP/IP protocol that converts IP addresses into physical addresses. This table allows
network managers to view, define, modify and delete ARP information for specific devices. Static entries can be defined in the
ARP Table. When static entries are defined, a permanent entry is entered and is used to translate IP address to MAC addresses. To
open the Static ARP Table open the Configuration folder, and then open the Layer 3 IP Networking folder and click on the
Static ARP Settings link.
Figure 9 - 9. Static ARP Settings window
To add a new entry, click the Add button, revealing the following screen to configure: