D-Link DES-3350SR User Manual - page 127
D-Link DES-3350SR Standalone Layer 3 Switch
117
The highest IP address will be the
Designated Router and is determined by
the OSPF Hello Protocol of the Switch.
DR Address
The IP address of the aforementioned
Designated Router.
Backup DR Address
The IP address of the aforementioned
Backup Designated Router.
Transmit Delay
A read only field that denotes the estimated
time to transmit a Link State Update Packet
over this interface, in seconds.
Retransmit Time
A read only field that denotes the time
between LSA retransmissions over this
interface, in seconds.
OSPF Virtual Link Settings
Click the OSPF Virtual Interface Settings link to view the current OSPF Virtual Interface Settings. There are not virtual
interface settings configured by default, so the first time this table is viewed there will be not interfaces listed. To add a new OSPF
virtual interface configuration set to the table, click the Add button. A new menu appears (see below). To change an existing
configuration, click on the hyperlinked Transit Area ID for the set you want to change. The menu to modify an existing set is the
same as the menu used to add a new one. To eliminate an existing configuration, click the
in the Delete column.
Figure 9 - 31. OSPF Virtual Link Settings table
The status of the virtual interface appears (Up or Down) in the Status column.
Figure 9 - 32. OSPF Virtual Link Setting –Add
Configure the following parameters if you are adding or changing an OSPF Virtual Interface:
Parameters Description
Transit Area ID
Allows the entry of an OSPF Area ID
−
previously defined on the Switch
− that
allows a remote area to communicate with
the backbone (area 0). A Transit Area
cannot be a Stub Area or a Backbone
Area.