D-Link DES-3350SR User Manual - page 129
D-Link DES-3350SR Standalone Layer 3 Switch
119
Use the menu below to change settings or add a new OSPF Area Aggregation setting.
Figure 9 - 34. OSPF Area Aggregation Settings - Add
Specify the OSPF aggregation settings and click the Apply button to add or change the settings. The new settings will appear listed
in the OSPF Area Aggregation Configuration table.
Use the following parameters to configure the following settings for OSPF Area Aggregation:
Parameters Description
Area ID
Allows the entry the OSPF Area ID for
which the routing information will be
aggregated. This Area ID must be
previously defined on the Switch.
Network Number
Sometimes called the Network Address.
The 32-bit number in the form of an IP
address that uniquely identifies the network
that corresponds to the OSPF Area above.
Network Mask
The corresponding network mask for the
Network Number specified above.
LSDB Type
Specifies the type of address aggregation,
which is set at Summary.
Advertisement
Select Enabled or Disabled to determine
whether the selected OSPF Area will
advertise it’s summary LSDB (Network-
Number and Network-Mask).
Advertisement
Select Enabled or Disabled to determine
whether the selected OSPF Area will
advertise it’s summary LSDB (Network-
Number and Network-Mask).
Click Apply to implement changes made.
OSPF Host Route Settings
OSPF host routes work in a way analogous to RIP, only this is used to share OSPF information with other OSPF routers. This is
used to work around problems that might prevent OSPF information sharing between routers.
To configure OSPF host routes, click the OSPF Host Route Settings link. To add a new OSPF Route, click the Add button.
Configure the setting in the menu that appears. The Add and Modify menus for OSPF host route setting are nearly identical. The
difference being that if you are changing an existing configuration you will be unable to change the Host Address. To change an
existing configuration, click on the hyperlinked Host Address in the list for the configuration you want to change and proceed to
change the metric or area ID. To eliminate an existing configuration, click the
in the Delete column for the configuration being
removed.
Figure 9 - 35. OSPF Host Route Settings table
Use the menu below to set up OSPF host routes.