D-Link DES-3350SR User Manual - page 73
D-Link DES-3350SR Standalone Layer 3 Switch
63
Replace priority with
− Click the
corresponding box if you want to re-write
the 802.1p default priority of a packet to
the value entered in the Priority field,
which meets the criteria specified
previously in this command, before
forwarding it on to the specified CoS
queue. Otherwise, a packet will have its
incoming 802.1p user priority re-written
to its original value before being
forwarded by the Switch.
For more information on priority queues,
CoS queues and mapping for 802.1p,
see the QoS section of this manual.
VLAN Name
Allows the entry of a name for a
previously configured VLAN.
Source MAC
Source MAC Address - Enter a MAC
Address for the source MAC address.
Destination MAC
Destination MAC Address - Enter a MAC
Address mask for the destination MAC
address.
802.1p (0-7)
Enter a value from 0-7 to specify that the
access profile will apply only to packets
with this 802.1p priority value.
Ethernet Type
Specifies that the access profile will
apply only to packets with this
hexadecimal 802.1Q Ethernet type value
(hex 0x0-0xffff) in the packet header. The
Ethernet type value may be set in the
form: hex 0x0-0xffff, which means the
user may choose any combination of
letters and numbers ranging from a-f and
from 0-9999.
To view the settings of a previously correctly configured rule, click
in the Access Rule Table to view the following screen:
Figure 7 - 46. Access Rule Display window (Ethernet)
Packet Content Mask
To configure the Access Rule for Packet Content Mask, open the Access Profile Table and click Modify for a Packet Content
Mask entry. This will open the following screen: