D-Link DES-3350SR User Manual - page 64
D-Link DES-3350SR Standalone Layer 3 Switch
54
Enter the port range in the From and To fields, select the desired Mode in the next field, and then click Apply to let your changes
take effect.
Access Profile Table
Access profiles allow you to establish criteria to determine whether the Switch will forward packets based on the information
contained in each packet's header. These criteria can be specified on a basis of VLAN, MAC address or IP address.
Creating an access profile is divided into two basic parts. The first is to specify which part or parts of a frame the Switch will
examine, such as the MAC source address or the IP destination address. The second part is entering the criteria the Switch will use
to determine what to do with the frame. The entire process is described below in two parts.
Part 1
To display the currently configured Access Profiles on the Switch, open the Configuration folder and click on the Access Profile
Table link. This will open the Access Profile Table page, as shown below.
Figure 7 - 37. Access Profile Table
To add an entry to the Access Profile Table, click the Add button. This will open the Access Profile Configuration page, as
shown below. There are three Access Profile Configuration pages; one for Ethernet (or MAC address-based) profile
configuration, one for IP address-based profile configuration and one for the Packet Content Mask. You can switch between the
three Access Profile Configuration pages by using the Type drop-down menu. The page shown below is the Ethernet Access
Profile Configuration page.
Ethernet
Figure 7 - 38. Access Profile Table (Ethernet)
The following parameters can be set, for the Ethernet type:
Parameter
Description
Profile ID (1-255)
Type in a unique identifier number for
this profile set. This value can be set
from 1 - 255.