D-Link DES-3350SR User Manual - page 66
D-Link DES-3350SR Standalone Layer 3 Switch
56
Figure 7 - 39. Access Profile Configuration (IP)
The following parameters can be set, for IP:
Parameter
Description
Profile ID (1-255)
Type in a unique identifier number for
this profile set. This value can be set
from 1 - 255.
Type
Select profile based on Ethernet (MAC
Address), IP address or packet content
mask. This will change the menu
according to the requirements for the
type of profile.
Select Ethernet to instruct the Switch to
examine the layer 2 part of each packet
header.
Select IP to instruct the Switch to
examine the IP address in each frame's
header.
Select Packet Content Mask to specify a
mask to hide the content of the packet
header.
VLAN
Selecting this option instructs the Switch
to examine the VLAN part of each packet
header and use this as the, or part of the
criterion for forwarding.
Source IP Mask
Enter an IP address mask for the source
IP address.
Destination IP Mask
Enter an IP address mask for the
destination IP address.
DSCP
Selecting this option instructs the Switch
to examine the DiffServ Code part of
each packet header and use this as the,
or part of the criterion for forwarding.
Protocol
Selecting this option instructs the Switch
to examine the protocol type value in
each frame's header. You must then