D-Link DES-3350SR User Manual - page 130
D-Link DES-3350SR Standalone Layer 3 Switch
120
Figure 9 - 36. OSPF Host Route Settings - Add
Specify the host route settings and click the Apply button to add or change the settings. The new settings will appear listed in the
OSPF Host Route Settings list. The following fields are configured for OSPF host route.
Parameters Description
Host Address
The IP address of the OSPF host.
Metric
A value between 1 and 65535 that will be
advertised for the route.
Area ID
A 32-bit number in the form of an IP
address (xxx.xxx.xxx.xxx) that uniquely
identifies the OSPF area in the OSPF
domain.
DHCP / BOOTP Relay
The BOOTP hops count limit allows the maximum number of hops (routers) that the BOOTP messages can be relayed through to
be set. If a packet’s hop count is more than the hop count limit, the packet is dropped. The range is between 1 and 16 hops, with a
default value of 4. The relay time threshold sets the minimum time (in seconds) that the Switch will wait before forwarding a
BOOTREQUEST packet. If the value in the seconds field of the packet is less than the relay time threshold, the packet will be
dropped. The range is between 0 and 65,536 seconds, with a default value of 0 seconds.
DHCP / BOOTP Relay Information
To enable and configure BOOTP or DHCP on the Switch, click Configuration > DHCP/BOOTP Relay > DHCP/BOOTP Relay
Information:
Figure 9 - 37. DHCP/ BOOTP Relay Global Settings window
The following fields can be set:
Parameters Description
BOOTP Relay State
This field can be toggled between Enabled
and Disabled using the pull-down menu. It
is used to enable or disable the
BOOTP/DHCP Relay service on the
Switch. The default is Disabled
BOOTP Relay Hops
Count Limit (1-16)
This field allows an entry between 1 and 16
to define the maximum number of router
hops BOOTP messages can be forwarded
across. The default hop count is 4.
BOOTP Relay Time
Threshold (0-65535)
Allows an entry between 0 and 65535
seconds, and defines the maximum time
limit for routing a BOOTP/DHCP packet. If