D-Link DES-3350SR User Manual - page 88
D-Link DES-3350SR Standalone Layer 3 Switch
78
Reauthenticate Ports for Port Based 802.1x
This window allows you to reauthenticate a port or group of ports. The Reauthenticate Port Table displays the current status of the
port(s) once you have clicked Apply.
Click Reauthenticate Port(s) on the PAE Access Entity folder on the Configuration menu to open the Reauthenticate Port(s)
window:
Figure 7 - 66. Reauthenticate Port window
This window displays the following information:
Parameter
Description
Port
The port number.
MAC Address
The MAC address of the switch where the
port resides.
Auth State
The Authenticator State will display one of
the following: Initialize, Disconnected,
Connecting, Authenticating, Authenticated,
Aborting, Held, ForceAuth, ForceUnauth,
and N/A.
BackendState
The Backend State will display one of the
following: Request, Response, Success, Fail,
Timeout, Idle, Initialize, and N/A.
Oper Dir
The Operational Controlled Directions are
both and in.
PortStatus
The status of the controlled port can be
authorized, unauthorized, or N/A.
Reauthenticate Ports for MAC-based 802.1x
To reauthenticate ports for the MAC side of 802.1x, the user must first enable 802.1x by MAC address in the Advanced Settings
window. Click Configuration > Port Access Entity > PAE System Control > Reauthenticate Port(s) to open the following
window:
Figure 7 - 67. Reauthenticate Port(s) for MAC-based 802.1x window
To reauthenticate ports, first choose the switch in the switch stack by using the Unit pull-down menu, then the range of ports in the
From and To field. Then the user must specify the MAC address to be reauthenticated by entering it into the MAC Address field
and checking the corresponding check box. To begin the reauthentication, click Apply.